Installation & Assembly

ASSEMBLY INSTRUCTIONS FOR YOUR
BLING SCONCE
S1001 & Z1001
IMPORTANT SAFETY INSTRUCTIONS:
*These instructions are provided for your safety. It is very important that they are read completely before beginning the installation of your xture.
*DIRECT WIRE FIXTURES: WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED ELECTRICIAN.
*Turn the power to xture off before replacing bulbs, making sure the bulbs have sufcient time to cool down. Do not subject the xture to any
shock while lit as shattering of bulbs may result.
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE
MAIN FUSE BOX/CIRCUIT BREAKER.
2. Remove all parts from carton. Do not throw away any parts.
3. Remove decorative nuts (B) from screws (D). Remove backplate and
socket cluster (A) from frame (C).
4. Pulling wiring from “J BOX” and guide through large hole in
universal mounting pattern cutout in frame (C).
5. Afx frame (C) to “J BOX” using screws (E) provided.
6. Hold backplate (A) near wiring from “J BOX” and make proper
electrical connections.
7. Connect ground wire (green/silver/copper) from the xture to the
ground wire in outlet box. Connect the black wire of the xture (or
smooth side of the wire) to the black wire in the outlet box using wire
nuts (H). Connect the white wire of the xture (or rough side of the
wire) to the white wire in the outlet box using wire nuts (H).
8. Push wiring back into “J BOX” and afx backplate (A) to frame (C)
using decorative nuts (B).
9. Install two (2) 60W max. Type G16 (GLOBE) candelabra base bulbs
into sockets.
ASSEMBLY INSTRUCTIONS
A
"J BOX"
B
C
D
B
H
H
D
C
D
F
G
ASSEMBLED SCONCE
E
E
CARE INSTRUCTIONS:
*To clean, use a soft cloth only. DO NOT use any chemical or abrasive cleaners.
*White gloves have been shipped with each sconce. Please wear gloves to keep the
xture clean during installation.
GLASS DROP INSTALLATION:
**It is recommended to use needle nose pliers (not included) when install the small glass drops (F).**
**Recommended by the vendor to install the glass drops (F & G) on the bottom band rst and continue upwards to the top band.
**Reference the “Assembled Sconce” illustration above for glass drop (F & G) orientation.**
1. Remove packaging from glass drops (F & G). NOTE: The xture is designed to have alternating size glass drops (F & G) on
each band.
2. Start with a large glass drop (G). Notice the metal connection attached to each glass drop has a large and small side. Please
see images below for reference. Insert the larger connection side into a hole in the band. With your index nger guide the
smaller connection side into the hole securing glass drop (G) to the band. NOTE: A small amount of adjustment maybe
needed for each drop to hang straight.
3. Needle nose pliers are recommended when installing small glass drops (F).
4. Locate the large and small connection side of the small glass drop (F). Firmly hold the vertical section (smaller connection
side) of the metal connection with the needle nose pliers (see images below for reference). Insert the large connection side
(same procedure as the large glass drop (G)) into the hole on the left/right side of installed large glass drop (G). Using the
pliers insert the small connection side into the hole securing glass drop (F) to the band.
5. Repeat steps 2 and 4 for each band until all glass drops (F & G) are installed.