Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
SIMON CHANDELIER
1551
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY AT FUSE BOX/ CIRCUIT BREAKER.
2. Remove all parts from carton. Do not throw away any parts.
3. Remove quick link (G) from hang straight (F). Keep quick link (G) attached to loop (H).
4. Remove cross bar (A) (with threaded tube (B) and hang straight (F) attached) from canopy (D) by unscrewing collar (E).
Afx cross bar (A) to ceiling outlet box using screws (C) provided.
5. Thread bottom extension tube (I) onto threaded tube (J).
6. Measure desired drop for xture to hang and add/remove extension tubes (I) to reach desired position. Guide wiring through
extension tubes before threading tubes together. **TO ADD/REMOVE EXTENSIONS: (Un)Thread the threaded tube of one
extension out of/ into the threaded opening of the next extension. Make sure wiring is pulled tight when threading extensions
together to prevent damage to the wire.**
7. Carefully slide threaded collar (E) down extensions (I) until it rests on shade housing (K). Carefully slide canopy (D) down
extensions (I) until it rests on collar (E).
8. Lift xture to ceiling and secure quick link (G) to hang straight (F). Carefully guide wire through hang straight (F) and
threaded tube (B) into ceiling outlet box.
9. Make proper electrical connections noted in steps 10-12. A LICENSED ELECTRICIAN IS RECOMMENDED.
10. Attach ground wire from xture (green or silver in color) to ground wire from outlet box. Fasten wires together with wire
nut (N). Tightly wrap connection with electrical tape.
11. Attach hot wire from xture (black in color or smooth side of wire) to hot wire from outlet box. Fasten wires together with
wire nut (N) and tightly wrap connection with electrical tape.
12. Attach neutral wire from xture (white in color or ribbed side of wire) to neutral wire from outlet box. Fasten wires together
with wire nut (N) and tightly wrap connection with electrical tape.
13. Gently push wire connections back into ceiling outlet box.
14. Slide canopy (D) up extensions (I) and hold ush against ceiling. To secure position of canopy (D), slide collar (E) up
extensions (I) and thread onto hang straight (F). Turn until hand tight.
15. Use handle (M) to move shade (L) into desired position. Repeat this step for remaining shades. To avoid touching a hot
surface, make sure xture is switched off when adjusting the position of the shades.
16. Install six 60W MAX., type A, medium base bulbs into sockets located inside shades (L).
17. Reconnect main electrical supply at fuse box/ circuit breaker and test the xture.
*These instructions are provided for your safety. It is very important that they are read completely before beginning the
installation of your xture.
*WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED ELECTRICIAN.
*Turn off power at switch before replacing bulbs
*If any special control devices are used with this xture, follow the instructions carefully to assure full compliance with N.E.C.
requirements. If there are any questions, contact a qualied electrical contractor.
IMPORTANT SAFETY INSTRUCTIONS:
***To clean, use soft cloth only. Do not use any chemical or abrasive cleaners.***