Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
LARGE SPUTNIK CHANDELIER
(A)
(I)
(J)
(J)
(J)
(J)
(K)
(B)
(D)
(C)
(E)
(F)
(G)
(OUTLET BOX)
(H)
714
ASSEMBLY INSTRUCTIONS
**SHUT OFF ELECTRICAL SUPPLY AT CIRCUIT BREAKER**
1. Remove all parts carefully from the carton. Do not throw away any parts.
2. Remove cross bar (B) from hang straight (G) by unthreading tube (C) from hang
straight (G). Af x cross bar (B), including threaded tube (C), to ceiling outlet box
using cross bar screws (D) provided.
3. Measure desired drop for xture to hang and add/remove extension tubes (J) as
needed. Guide wiring through extension tubes before threading tubes together.
**TO ADD/REMOVE EXTENSIONS: (Un)Thread the threaded nipple of one extension
into/out of the threaded opening of the next extension. Make sure electrical cord is
pulled tight when threading extensions together to prevent damage to the wiring.**
4. Thread bottom extension (J) onto the threaded tube located at the top of housing (K).
5. Guide wiring from top extension (J) through center hole in hang straight (G) and
through center hole in canopy (E).
6. Unthread collar (F) from hang straight (G). Slide collar (F) and canopy (E) down
extensions (J) until they rest on housing (K).
7. Attach loop (I) and hang straight (G) using quick link (H).
8. Lift xture to ceiling outlet box. Guide wiring through threaded tube (C). Thread hang
straight (G) onto threaded tube (C).
9. Pull wiring from ceiling outlet box and make proper electrical connections described
in steps 10-12. A LICENSED ELECTRICIAN IS RECOMMENDED.
10. Attach ground wire from xture (green or silver in color) to ground wire from outlet
box. Fasten wires together with wire nut (A). Wrap connection with electrical tape.
IMPORTANT SAFETY INSTRUCTIONS:
*These instructions are provided for your safety. It is very important that they are read
completely before beginning the installation of your xture.
*Turn off power at switch before replacing bulbs.
*If any special control devices are used with this xture, follow the instructions carefully
to assure full compliance with N.E.C. requirements. If there are any questions, contact a
quali ed electrical contractor.
*We strongly recommend installation by a licensed electrician.
11. Attach hot wire from xture (black in color or smooth
side of wire to hot wire from outlet box. Fasten wires
together with wire nut (A). Wrap connection with
electrical tape.
12. Attach neutral wire from xture (white in color or
ribbed side of wire) to neutral wire from outlet box.
Fasten wires together with wire nut (A). Wrap
connection with electrical tape.
13. Carefully push wire connections back into ceiling
outlet box.
14. Slide canopy (E) up extensions (J) and hold rmly
against ceiling. Slide collar (F) up extensions (J) and
thread onto hang straight (G) to secure canopy (E)
against the ceiling.
15. Install twenty four 40W MAX. G16, Candelabra base
bulbs into the sockets.
16. Reconnect main electrical supply from the fuse box/
circuit breaker and test the xture.
*To clean, use soft cloth only. Do not use any chemical or
abrasive cleaners.*

Summary of content (1 pages)