Installation Guide

Z2188
(G)
(B)
(A)
(C)
(H)
OUTLET BOX
(F)
(E)
(D)
(I)
(I)
(I)
(L)
(K)
(I)
(J)
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY AT
FUSE BOX/ CIRCUIT BREAKER.
2. Remove parts from carton and discard packing material.
3. Remove mounting plate (B) from canopy (D) by
removing screws (E). Set screws (E) aside.
4. Afx mounting plate (B) to ceiling outlet box with
mounting screws (C) provided.
5. Measure desired drop for xture to hang and add/remove
extension tubes (I) as needed. Guide wiring through
extension tubes before threading tubes together.
**TO ADD/REMOVE EXTENSIONS: (Un)Thread the
threaded nipple of one extension into/ out of the threaded
opening of the next extension. Make sure electrical cord
is pulled tight when threading extensions together to
prevent damage to the wiring.**
6. Connect hang straight (F) to loop (H) with quick link (G).
7. Thread bottom extension tube (I) onto threaded nipple (J).
8. Guide wiring from top extension (I) through loop (H),
quick link (G) and hang straight (F), exiting canopy (D).
Lift canopy (D) to ceiling outlet box.
9. Make the proper electrical connections described in steps
10 -12. A LICENSED ELECTRICIAN IS
RECOMMENDED.
10. Attach ground wire from xture (green or silver in color)
to ground wire from outlet box. Fasten wires together
with wire nut (A) and tightly wrap connection with
electrical tape.
11. Attach hot wire from xture (black in color or smooth
side of wire) to hot wire from outlet box. Fasten wires
together with wire nut (A) and tightly wrap connection
with electrical tape.
IMPORTANT SAFETY INSTRUCTIONS:
* These instructions are provided for your safety. It is
very important that they are read completely before
beginning the installation of your xture.
* WE STRONGLY RECOMMEND INSTALLATION
BY A LICENSED ELECTRICIAN.
* Turn off power at switch before replacing bulbs, making
sure xture has had sufcient time to cool down.
* DO NOT subject the xture to any shock while lit as
shattering of bulbs may result.
ASSEMBLY INSTRUCTIONS FOR YOUR
SATURNIA CHANDELIER
12. Attach neutral wire from xture (white in color or ribbed side of wire) to neutral wire from outlet box. Fasten wires together with
wire nut (A) and tightly wrap connection with electrical tape. Carefully push the wire connections back into the ceiling outlet box.
13. Place canopy (D) over mounting plate (B). Thread canopy screws (E) into holes in canopy (D), and mounting plate (B) to secure
xture to ceiling.
14. Place shades (K) onto sockets (L).
15. Insert six (6) 60W MAX. G16.5, candelabra base bulbs into sockets (L).
16. Reconnect main electrical supply from the fuse box/ circuit breaker and test the xture.
***To clean, use soft cloth only. Do not use any chemical or abrasive cleaners.***