Installation Guide

400
ASSEMBLY INSTRUCTIONS:
IMPORTANT SAFETY INSTRUCTIONS:
* This lamp has a polarized plug (one blade is wider than the other) as a feature
to reduce the risk of electric shock. This plug will t in a polarized outlet only
one way. If it does not t fully in the outlet, reverse the plug. If it still does
not t, contact a qualied electrician. Do NOT alter the plug.
* Do not use with an extension cord unless the plug from the lamp can be fully
inserted into the extension cord receptacle.
* Switch power o and remove plug from the wall outlet before replacing the
bulb.
* This lamp is UL rated for dry locations.
* The marble tray is designed for up to 10 lbs. on a single side. Do not exceed
the maximum weight limit on any one side.
**To clean, use a soft cloth only. Do not use any chemical or abrasive cleaners.**
MARTIN DOUBLE COLUMN TRAY FLOOR LAMP
ASSEMBLY INSTRUCTIONS FOR YOUR
1. Unpack all parts and remove packing materials. Place parts on a level surface.
2. Please note: legs (M) are labeled with stickers that correspond with stickers
on channels (N). Slide the leg labeled with sticker number one (1) into the top
of the channel labeled with matching sticker. Repeat with the remaining legs.
3. Pulling cord taut from below the assembled legs (R) so wiring does not
become damaged, thread column (K) onto assembled legs (R). Repeat step on
opposite side.
4. Slide marble (I) and washer (H) onto threaded tube (J). Repeat step on
opposite side.
5. Using wrench (P), back screws (G) out of holes in double column (F). Slide
double column (F) onto threaded tubes (J). Use wrench (P) to tighten screws
until hand tight, securing column (F) in place.
6. To secure legs in place, carefully turn lamp over on its side. Use wrench (Q)
to tighten set screws (O). Rotate wrench until hand tight.
7. Set lamp upright and remove nial (A) and shade bracket (B) from shade
riser (D).
8. Thread shade riser (D) onto socket housing (E).
9. Place shade (C) onto shade riser (D). Place shade lock (B) onto shade riser
(D). Note: shade lock (B) should be turned so cutouts t over alignment arms
located at the top of shade riser (D).
10. Thread nial (A) onto shade riser (D) to secure the shade to the lamp.
11. Install two 100W max., type A, medium base bulbs into the socket.
12. Remove protective plastic from plug (S).
13. Insert plug (S) into wall outlet. Control power to lamp by operating full
range dimmer on cord.
(B)
Bottom View:
(A)
(C)
(D)
(E)
(F)
(G)
(H)
(I)
(J)
(K)
(L)
(M)
(O)
(N)
(Q)
(Q)
(R)
(S)
(P)