User's Guide

JOBNAME: 1093929-2013-asd-own PAGE: 121 SESS: 4 OUTPUT: Tue Mar 27 10:39:14 2012
4. At the receiver located on the garage door
opener motor in the garage, locate the
“learn”or “smart”button (the name and color
of the button may vary by manufacturer but it
is usually located near where the hanging
antenna wire is attached to the unit). If there
is difficulty locating the button, reference the
garage door opener’s manual.
5. Press and release the “learn” or “smart” but-
ton.
6. Return to the vehicle and firmly press and
hold the trained HomeLinkT button for two
seconds and release. Repeat the
“press/hold/release” sequence up to 3
times to complete the training process.
HomeLinkT should now activate your rolling
code equipped device.
7. If you have any questions or are having diffi-
culty programming your HomeLinkT buttons,
refer to the HomeLinkT web site at:
www.homelink.com or call 1-800-355-
3515.
PROGRAMMING HOMELINKT FOR
CANADIAN CUSTOMERS AND
GATE OPENERS
Canadian radio-frequency laws require transmit-
ter signals to “time-out” (or quit) after several
seconds of transmission – which may not be long
enough for HomeLinkT to pick up the signal
during training. Similar to this Canadian law,
some U.S. gate operators are designed to “tim-
eout” in the same manner.
If you live in Canada or you are having difficulties
training a gate operator or garage door opener
by using the “Training” procedures, replace
“Programming HomeLinkT” Step 2 with the fol-
lowing:
NOTE:
When programming a garage door opener,
etc., unplug the device during the “cycling”
process to prevent possible damage to the
garage door opener components.
1. See “Programing HomeLinkT” step 1 earlier
in this section.
2. Using both hands, simultaneously press and
hold the desired HomeLinkT button and the
hand-held transmitter button. During train-
ing, your hand-held transmitter may auto-
matically stop transmitting. Continue to
press and hold the desired HomeLinkT but-
ton while you press and re-press (“cycle”)
your hand-held transmitter every two sec-
onds until the frequency signal has been
learned. The HomeLinkT indicator light will
flash slowly and then rapidly after several
seconds upon successful training. DO NOT
release until the HomeLinkT indicator light
flashes slowly and then rapidly. When the
indicator light flashes rapidly, both buttons
may be released. The rapid flashing indi-
cates successful training.
Proceed with “Programming HomeLinkT”
step 3 to complete.
If the device was unplugged during the pro-
gramming procedure, remember to plug it
back in when programming is completed.
OPERATING THE HOMELINKT
UNIVERSAL TRANSCEIVER
The HomeLinkT Universal Transceiver, after it is
programmed, can be used to activate the pro-
grammed device. To operate, simply press and
release the appropriate programmed HomeLinkT
Universal Transceiver button. The amber indica-
tor light will illuminate while the signal is being
transmitted.
For convenience, the hand-held transmitter of the
device may also be used at any time.
Instruments and controls 2-51
Z REVIEW COPY—
2013 Altima Sedan (asd)
Owners Manual—USA_English (nna)
03/24/12—dmoore
X