User's Guide

JOBNAME: 1093929-2013-asd-own PAGE: 122 SESS: 4 OUTPUT: Tue Mar 27 10:39:14 2012
PROGRAMMING TROUBLE-
DIAGNOSIS
If the HomeLinkT does not quickly learn the hand-
held transmitter information:
● replace the hand-held transmitter batteries
with new batteries.
● position the hand-held transmitter with its
battery area facing away from the
HomeLinkT surface.
● press and hold both the HomeLinkT and
hand-held transmitter buttons without inter-
ruption.
● position the hand-held transmitter 1 - 3
inches (26 - 76 mm) away from the
HomeLinkT surface. Hold the transmitter in
that position for up to 15 seconds. If
HomeLinkT is not programmed within that
time, try holding the transmitter in another
position – keeping the indicator light in view
at all times.
If you have any questions or are having difficulty
programming your HomeLinkT buttons, refer to
the HomeLinkT web site at: www.homelink.com
or call 1-800-355-3515.
CLEARING THE PROGRAMMED
INFORMATION
The following procedure clears the programmed
information from both buttons. Individual buttons
cannot be cleared. However, individual buttons
can be reprogrammed, see “Reprogramming a
single HomeLinkT button” in this section.
To clear all programming:
1. Press and hold the two outer HomeLinkT
buttons until the indicator light begins to
flash in approximately 10 seconds. Do not
hold for longer than 20 seconds.
2. Release both buttons.
HomeLinkT is now in the programming mode and
can be programmed at any time beginning with
“Programming HomeLinkT” - Step 1.
REPROGRAMMING A SINGLE
HOMELINKT BUTTON
To reprogram a HomeLinkT Universal Transceiver
button, complete the following:
1. Press and hold the desired HomeLinkT but-
ton. DO NOT release the button.
2. The indicator light will begin to flash after 20
seconds. Without releasing the HomeLinkT
button, proceed with “Programming
HomeLinkT” - Step 1.
For questions or comments, contact HomeLinkT
at: www.homelink.com or 1–800–355–3515.
The HomeLinkT Universal Transceiver button has
now been reprogrammed. The new device can
be activated by pushing the HomeLinkT button
that was just programmed. This procedure will
not affect any other programmed HomeLinkT
buttons.
IF YOUR VEHICLE IS STOLEN
If your vehicle is stolen, you should change the
codes of any non-rolling code device that has
been programmed into HomeLinkT. Consult the
Owner’s Manual of each device or call the manu-
facturer or dealer of those devices for additional
information.
When your vehicle is recovered, you will
need to reprogram the HomeLinkT Univer-
sal Transceiver with your new transmitter
information.
2-52 Instruments and controls
Z REVIEW COPY—
2013 Altima Sedan (asd)
Owners Manual—USA_English (nna)
03/24/12—dmoore
X