Installation Instructions

Power Tools
01 July 2016
Page 2 of 3
see figure below:
Additionally, to ensure an adequate performance of the antenna, no
metal parts are allowed in the exclusion areas defined in green. No plastic is
allowed in the orange exclusion areas and no plastic or metal is allowed in the
black exclusion areas, see figure below:
Device Power Supply
The transmitter described in this document is intended to be supplied by an
external voltage supply:
Either directly with nominal 3V by a CR2032 coin cell via the corresponding
and/or with nominal 3.3V ± 2% indirectly by a host device with pins.