Service manual

10
Motor
Vacuum
Proving
Switch
Thimble
(if applicable)
Mounting
Angle
Assembly
(Standard)
Tailpipe
4" X 8" Boot
5-6"
3.75"
7"- 8"
11.5"
10"
5-6"
4" X 8" Boot
7.5"
10.25"
4"
7"
5/8" Diameter
Mounitng Holes
Vacuum pump may be mounted by
using mounting angles as shown in
view "A" or "B".
NOTE: Typical assembly shown. Two
(2) assemblies per each
vacuum pump required.
Pump Mounting Instructions
(P/N 92113900)
Hex Nut
(P/N 96411600)
Spring Lock Washer
(P/N 95211600)
Flat Washer
(P/N 93413912)
Hex Head Screw
#5/16-18 X 3/4
(P/N 95211600)
Flat Washer
(P/N 01365000)
Mounting
Angle (4)
11.5" or 7"
Mounting Platform (Angle Assembly)
Mounting Platform (Optional Platform Assembly)
If mounting on an outside wall is not practical, it may be mounted on a platform suspended
from the ceiling, or for noise reduction, in an enclosure.
Figure 9
Figure 10
SIDE VIEW
TOP VIEW
EP-100 PUMP INSTALLATION, OPERATION AND SERVICE MANUAL
7"
11.5"
"A"
"B"