User's Manual

SECTION 5: MAJOR COMPONENT DESCRIPTIONS
11
SECTION 5: MAJOR COMPONENT DESCRIPTIONS
Burner (shown with Tube
Gasket)
Must be installed with the
flame observation window
facing down.
Reflector
(Aluminium or
Stainless Steel)
Alternate overlap as
shown on overview.
Minimum overlap is 18
cm.
Tube and Reflector Hanger
with Tube Clamp Package
Position this hanger no more
than 20cm away from the
burner assembly.
Recommended 100mm.
Coupling Assembly
with Lock
Reflector End Cap
Punch out center section to
accommodate heat exchanger
tube.
Fan Assembly (Includes Flange)
Fan Assembly is attached to the last
section of heat exchanger tubing
(Fan Tube).
Tube and Reflector Hanger
Suspend system from these
hangers.
Flex Gas Line
Tube
Heat Treated Aluminized Tube
Supplied in 3m lengths.
Burner Tube
Supplied in 3m lengths. Burner
tube is always the first tube after
the burner.
Reflector Support Strap, Wire
Form & #8 x 3/4 (3.9 x 19mm)
Screw
Fan Tube with Internal Swirler
Fan tube is
always the last tube on the heater
where the fan is attached.
Fan Flange Assembly
and Screws
U-Tube
Assembly
Turnbuckle
Adjuster
Bow
Shackle
Tee
Assembly
U-Tube
Support
Bracket
Damper Flange Assembly
For use on Multiburner Systems.