ROBERTS R9965 Sound for Generations All Weather Radio R9965.
Contents ............................................................................ 2 Controls .......................................................................... 3-5 Battery Operation .............................................................. 6 Using the AC Adaptor ....................................................... 6 Listening to the radio - FM ................................................ 7 Listening to the radio - Medium and Long wave ............... 8 Headphones ....................
Controls (Front) 1. Tuning dial 2. Waveband switch 3. Tuning indicator 4. Low battery indicator 5. Volume Control 1 2 3 4 5 If you need any further advice, please call our Technical Helpline on :- 3 020 8758 0338 (Mon-Fri) R9965.
Controls 6 (Left Side) 7 6. Rubber aerial 7. Carrying handle 4 R9965.
Controls (Right side) 8 8. Rubber socket cover 9 10 9. Headphone socket 10. DC input socket If you need any further advice, please call our Technical Helpline on :- 5 020 8758 0338 (Mon-Fri) R9965.
Battery operation 1. Open the Battery cover on the rear of your radio by removing the screw, lifting the cover flap and opening the door in a downward direction. 2. Insert four LR14 (C size) batteries into the spaces in the compartment. Take care to ensure all batteries are inserted with the correct polarity as shown inside the battery compartment. Replace the battery cover. 3. The low battery indicator will light when the batteries need replacing. 1 Using the AC adaptor 1.
Listening to the radio - FM 1. Select 'FM' using the Waveband switch. 2. Adjust the Volume control until a hissing sound is heard. 3. If not already fitted, screw the Rubber aerial into place on the top of the radio. 1 2 3 4. Carefully tune to the desired station using the Tuning control. The Tuning indicator will light when the station is correctly tuned. The FM band is marked on the upper half of the dial. 5. You may need to rotate your radio for optimum reception. 6.
Listening to the radio - Medium and Long wave 1. Select 'MW' or 'LW' using the Waveband switch. 1 2. Adjust the Volume control until a hissing sound is heard. 3. Carefully tune to the desired station using the Tuning control. The Tuning indicator will light when the station is correctly tuned. The MW and LW bands are marked on the lower half of the dial. 2 3 4. You may need to rotate your radio for optimum reception. 5. To switch off the radio set the Waveband switch to the 'Off' position.
Notes If you need any further advice, please call our Technical Helpline on :- 9 020 8758 0338 (Mon-Fri) R9965.
Specifications Circuit Features Power Requirements Mains AC 230 volts, 50Hz Batteries 4 x LR14 (C size) only. Loudspeaker 2 x 77mm 8ohms Output Power 2 x 1.6 Watts Headphone socket 3.5mm dia Aerial System FM Rubber aerial MW Built in Ferrite aerial LW Built in Ferrite aerial Frequency Coverage FM 87.5-108MHz MW 522- 1600kHz LW 144- 281kHz The Company reserves the right to amend the specification without notice. 10 R9965.
Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of charge. The guarantee does not cover: 1. Damage resulting from incorrect use. 2. Consequential damage. 3. Receivers with removed or defaced serial numbers. N.B.
ROBERTS RADIO TECHNICAL SERVICES 97-99 Worton Road Isleworth Middlesex TW7 6EG Technical Helpline:- 020 8758 0338 (Mon-Fri) Issue 1 R9965.
