Operation Manual

FM Radio

Manual tuning - FM

1. Fully extend the telescopic aerial. The aerial should be fully extended

and positioned vertically for optimum reception.

2. Press and release the On / Standby button to switch on your sound

system.

3. Press and release the Mode button until the FM band is selected.

4. Repeatedly press and release the Tuning Up or Down buttons to

tune to a station. The frequency will change in steps of 50kHz.

If the radio is tuned to a station of sufﬁ cient signal strength with RDS

information present, then the display may change to show the station

name.

5. When the end of the waveband is reached the radio will recommence

tuning from the opposite end.

6. Set the Volume to the desired setting.

7. To switch off your sound system press and release the On / Standby

button.

2,7

Note:

If you ﬁ nd that FM reception is poor, try repositioning the telescopic aerial.

Fully extend and position vertically for optimum reception. If you ﬁ nd that

an FM broadcast has a lot of background hiss, this may often be reduced

by setting the radio into Mono reception mode for the current FM station.

Please refer to the section 'Stereo / Mono setting - FM' on page 20 for

further details.

89.30MHz