Operation Manual

Display backlight dimmer

The brightness of the display can be adjusted when the radio is in standby

or when the unit is in use.

1. In order to adapt the intensity of the display to suit the ambient room

lighting, switch the Dimmer switch located on the left hand side of

your clock radio to select the dimmer brightness from High, Medium

and an almost off 'night-time' (Low) setting.

2. When the clock radio is in standby mode, pressing a button will cause

the radio to switch to the normal brightness level for a few seconds.

This is so that even if the standby brightness level is set to low (almost

off), it is still possible to see the time by quickly pressing a button.

Software version

The software display cannot be altered and is just for your reference.

Ensure your clock radio is switched on.

1. Press and release the Menu button.

2. Press the Tuning Up or Down buttons until 'SW VER' appears on

the display.

3. Press and release the Select button. The display shows the software

information.

4. Press and release the Menu button to exit the software display.

1,4