ROBERTS CR950 Sound for Generations 3 Band Radio Controlled Digital Clock Radio CR950 Instruction Book.
Controls (Front) 1 2 3 4 5 6 20 19 18 17 16 15 14 If you need any further advice, please call our Technical Helpline on 13 12 11 10 9 8 1. Snooze/Date button 8. Alarm 2 function switch 15. Radio On/Off button 2. Week end cancel indicator 9. Auto summer indicator 16. Alarm 2 button 3. Signal/Day of week indicators 10. Tuning scale 17. Alarm 1 button 4. Alarm 1 function switch 11. Alarm 1 indicator 18. Forward button 5. Waveband selector 12. Alarm 2 indicator 19. Time button 6.
Controls (Underside) 21 21. Display dimmer switch 22. Backup battery cover 22 3 CR950 Instruction Book.
General Fuse Do not allow this unit to be exposed to water or steam. Do not leave the unit where excessive heat could cause damage. It is recommended that the FM band be used wherever possible as better results in terms of quality and freedom from interference will usually be obtained than on the MW or LW bands. This apparatus must be protected by a 3A fuse (BS1362) in a 13A plug (BS1363). If another type of plug is used a 5A fuse should be fitted in the plug, adaptor or distribution board.
How to Optimise the Time Signal Reception forward (18) or reverse button (20) until the correct year appears. The time setting or synchronisation takes 2 to 3 minutes to complete if the reception of the radio time signal is undisturbed. This process will take longer if the time signal level is very weak (e.g. in locations that are a long distance from the MSF transmitter) or if it is subject to interference from thunderstorms, nearby TV sets, computers or household appliances that are not suppressed, etc.
Setting the Alarm Time Snooze Control To set the alarm time, press and hold down the Alarm 1 (17) or Alarm 2 (16) buttons and adjust using the forward (18) or reverse (20) buttons until the required time appears. The radio or buzzer alarm can be silenced for 5 minutes by pressing the Snooze button (1). This sequence can be repeated within the 60 minute alarm period. Waking Up to Radio Sleep Timer Set the alarm time as previously described. Switch on the radio and tune into the required station.
Specifications Circuit Features Power Requirements Mains AC 230-240 volts , 50Hz Backup Battery IEC size 6LR61 (6F22, PP3) Frequency Coverage FM Loudspeaker 75mm diameter 8 ohms Output Power 400mW RMS Aerial System FM Wire Aerial MW Built-in Ferrite aerial LW Built-in Ferrite aerial only 87.
Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of charge. The guarantee does not cover: 1. Damage resulting from incorrect use. 2. Consequential damage. 3. Receivers with removed or defaced serial numbers. .