Sound for Generations ROBERTS CR960 2 Band Stereo Dual Alarm Clock Radio Please read this manual before use
Controls 1 2 3 4 5 (Front) (Left hand end) 8 7 10 1. Alarm 2 indicator 2. Alarm 1 indicator 3. Auto dimmer 4. Clock display 5. PM indicator 6. LED Dial pointer 7. Stereo indicator 8. Alarm 2 function switch 9. Alarm 1 function switch If you need any further advice, please call our Technical Helpline on (Right hand end) 6 9 10. Tuning control 11.
Controls 14 (Top) 15 (Rear) 12 13 12. Off button 13. Sleep button 14. Radio On button 15. Snooze button 16. Waveband selector 17. Alarm set button 18. Slow forward button 19. Fast forward button 20. Fast reverse button 21. Slow reverse button 16 22. Time set button 18 17 23.
General Fuse Do not allow this unit to be exposed to water or steam. Do not leave the unit where excessive heat could cause damage. It is recommended that the FM band be used wherever possible as better results in terms of quality and freedom from interference will usually be obtained than on the MW band. This apparatus must be protected by a 3A fuse (BS1362) in a 13A plug (BS1363). If another type of plug is used a 5A fuse should be fitted in the plug, adaptor or distribution board.
is heard. Rotate the tuning control (10) until the desired station is received. If the station being received is in 'Stereo' the stereo indicator (7) will illuminate. Adjust the volume control (11) to the required sound level. Setting alarm time 1 Set the alarm 1 function switch (9) to the HWS or Radio position. The alarm 1 indicator (2) will show in the display. Press and hold down the alarm set button (17). Use the time adjust buttons (18-21) to adjust the time to the required setting: (18) S.
Wake up to Radio Auto Dimmer Set the alarm time as previously described. Switch on the radio by pressing the radio on button (14). Tune into the required station. Make sure that the station will be broadcasting at the time you wish to wake up. Set the volume control to the level of sound at which you want to wake to. Set the alarm 1 (9) or alarm 2 (8) function selector to the Radio position. The corresponding alarm 1 or alarm 2 indicator will light.
Specifications Circuit Features Power Requirements Mains Back-up Battery AC 230 volts, 50Hz IEC size 6F22 (6LR61, PP3) Frequency Coverage FM 87.5 -108MHz MW 520 - 1605kHz Loudspeaker 2 x 75mm diameter 8 ohms Output Power 2 x 0.5W RMS Aerial System FM Wire Aerial MW Built-in Ferrite aerial only Imported by:ROBERTS RADIO LIMITED PO BOX 130 MEXBOROUGH SOUTH YORKSHIRE S64 8YT The Company reserves the right to amend the specification without notice.
Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of charge. The guarantee does not cover: 1. Damage resulting from incorrect use. 2. Consequential damage. 3. Receivers with removed or defaced serial numbers. .
