Instructions / Assembly

SECTION 5: Fire-Fighting Measures
This section provides recommendations for fighting a fire caused by the chemical. The required information consists of:
FLASHPOINT: 649° F. METHOD: ASTM E136 NOTE: Estimated Minimum
FLAMMABLE LIMITS: NOTE: Not applicable
AUTOIGNITION TEMPERATURE: 649° F. NOTE: Estimated Minimum
GENERAL HAZARD: Solid material, may burn at or above the flashpoint, and airborne dust may explode if ignited. Toxic gases
will form upon combustion. Static Discharge, material can accumulate static charges which can cause an
incendiary electrical discharge.
FIRE FIGHTING: Use water spray to cool fire exposed surfaces, protect personnel, and extinguish the fire. Respiratory and
eye protection required for firefighting personnel.
HAZARDOUS COMBUSTION PRODUCTS: Oxygen-lean conditions may produce carbon monoxide and irritating smoke.
SECTION 6: Accidental Release Measures
General Information: Use proper personal protective equipment as indicated in Section 8.
Spills/Leak: Collect up, then place into suitable container for disposal. Keep away from heat or flame.
SECTION 7: Handling and Storage
Handling Precautions: Use with appropriate ventilation. Avoid generating fiber, avoid inhaling fiber.
Storage: Store in a cool, dry area away from heat or flame. Keep away from incompatible substances.
SECTION 8: Exposure Control / Personal Protection
Exposure Limit:
Composition: PE (reference: PNOS)
- TLV-TWA 10mg/m3 (ACGIH, inhalable fraction) 3mg/m3 (ACGIH, respirable fraction)
- PEL-TWA 15 mg/m3 (OSHA, total dust) 5mg/m3 (OSHA, respirable fraction).
Monitoring Methods: No information found
Engineering Controls: Use adequate ventilation to keep airborne concentrations below the permissible exposure limits. Facilities
storing or utilizing this material should be equipped with an eyewash facility and a safety shower.
Personal Protective Equipment:
Ø Eyes: No special requirement. It is recommended to wear chemical googles
Ø Skin: No special requirement. Wear appropriate gloves if necessary.
Ø Clothing: No special requirement. Wear appropriate working clothing to prevent skin exposure.
Ø Respirators: No special requirement.
SECTION 9: Physical and Chemical Properties
Physical State: Solid black plastic material
Odor: Odorless
pH: N/A
Molecular Formula: N/A
Molecular Weight: N/A
Viscosity: N/A
Boiling Point: N/A
Freezing/Melting Point: N/A
Decomposition Temperature: N/A
Specific Gravity/Density: N/A
Ignition Temperature: N/A
Solubility: Insoluble in water
2