User's Manual

Manual tuning - FM

1. Fully extend the wire aerial located on the rear of your clock radio.

Place the wire antenna so that it is as straight as possible extending

either above or below the radio.

2. Press the On / Standby button to switch on your clock radio.

3. Press the Function button to select the FM band.

4. Press the Tuning Up or Down button to tune to a station. The

frequency will change in steps of 50kHz.

If the radio is tuned to a station of sufﬁ cient signal strength with RDS

information present, then the display may change to show the station

name.

5. When the waveband end is reached the radio will recommence tuning

from the opposite waveband end.

6. Set the Volume to the desired setting.

7. To switch off your clock radio press the On / Standby button.

Note: (Headphones only)

If you ﬁ nd that FM reception is poor, try repositioning the wire aerial, up

or down or side to side.

If you ﬁ nd that an FM broadcast has a lot of background hiss, this may

often be reduced by setting the radio into Mono reception mode for the

current FM station. Please refer to the section "Stereo / Mono setting - FM"

on page 27 for further details.