Specifications

If you need any further advice, please call our Technical Helpline on :-

020 8758 0338 (Mon-Fri)

Operating your clock radio - FM auto-tune

1. Fully extend the wire aerial located on the rear of your clock radio.

Place the wire antenna so that it is as straight as possible extending

either above or below the clock radio.

2. Press the On / Standby button to switch on your clock radio.

3. Press and release the Band button until the FM band is selected.

4. Press and hold down the Tuning Up button for 2 - 3 seconds to cause

your radio to search from low frequency to high frequency and to stop

automatically when it ﬁ nds a station of sufﬁ cient strength.

5. After a few seconds the display will update. The display will show the

frequency of the signal found. If the signal is strong enough and there

is RDS data present then the radio may display the station name.

6. To ﬁ nd other stations press and hold the Tuning Up button as before.

7. Press and hold down the Tuning Down button for 2 - 3 seconds to

cause your radio to search from high frequency to low frequency and

to stop automatically when it ﬁ nds a station of sufﬁ cient strength.

8. When the end of the waveband is reached your radio will recommence

tuning from the opposite end of the waveband.

9. Adjust the Volume to the required setting.

10. To switch off your clock radio, press the On / Standby button.

Note:

If you ﬁ nd that FM reception is poor, try repositioning the wire aerial, up

or down or side to side.

If you ﬁ nd that an FM broadcast has a lot of background hiss, this may

often be reduced by setting the radio into Mono reception mode for the

current FM station. Please refer to the section "Stereo / Mono setting - FM"

on page 15 for further details.

2,10

4,6

FM Mode

87.50MHz

Scanning...