Specifications

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
4
Using the clock radio for the fi rst time
1. Place your clock radio on a fl at surface.
2. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is straight as possible extending
either above or below the radio.
3. Insert the adaptor plug into the DC socket located on the rear of your
clock radio. Plug the adaptor into a standard mains socket outlet. The
display will show 'Welcome to Digital Radio' for a few seconds and
then the display will show '0:00'. If a DAB signal is found it will then
show the current time in the display.
4. If no stations are found, '0:00' will be displayed. It may be necessary
to relocate your clock radio to a position giving better reception. You
should then carry out a scan to fi nd stations as described on page 8.
• IMPORTANT: The mains adaptor is used as the means of connecting
the clock radio to the mains supply. The mains socket used
for the clock radio must remain accessible during normal use. In order
to disconnect the radio from the mains completely, the mains
adaptor should be removed from the mains socket outlet
completely.
Characters appearing on the display indicate that the clock radio is
connected to and powered from the mains supply.
Welcome to
Digital Radio