Specifications

Operating your clock radio

1. Place the wire antenna so that it is as straight as possible extending

either above or below the radio.

2. Press and release the On / Standby button to switch on your clock

radio.

3. Press and release the Band button until the DAB mode is selected.

The display will show 'DAB Mode' for a few seconds.

4. If this is the ﬁ rst time the clock radio is used a scan of Band III DAB

channels may be carried out (depending on whether scanning was

already completed in standby mode). When the scan is completed the

ﬁ rst station (in numeric-alpha order 0...9...A...Z) will be selected. If the

radio has been used before, the last used station will be selected.

5. The display will show the station name on the upper line of the text

display and broadcast information on the lower line.

6. If no signals are found it may be necessary to relocate your clock radio

to a position giving better reception, and then repeat the scan using

the Auto-tune facility (see 'Finding New Stations - DAB' on page 8).

Note: that radio station name and frequency displays shown in this user

guide may differ from those that you see on your radio. Broadcasters may

change radio station names that are transmitted, and the frequencies

used for DAB and FM radio stations may not be the same in all parts of

the country.

Absolute Rad 60s

Now playing on the r

DAB Mode

Scanning... 24