Instruction manual

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
10
7. Press the Tuning Up or Down buttons to see the SSID for each access
point that the clock radio has found. If your network is shown proceed
to step 9.
8. If your network is not found, it is possible that it is confi gured such that
the SSID is not broadcast (sometimes referred to as hidden). If this
is the case then use the Back button and then select 'Enter network
name'. This procedure is described page 56, 'Entering the network
name manually'. If you know that your network name is not hidden, and
it was not found,then either try re-scanning, (press the Back button),
and if necessary try moving your clock radio to a location closer to
your access point / router, or refer to 'Troubleshooting' on page 61.
If you make a mistake at any point, use the Back button to go back
to the previous screen.
9. When the SSID for the access point you want to connect to is displayed
on the screen, press the Select button.
10. If your network is not confi gured to need an encryption code, the screen
should say 'Connecting to network', then 'Network OK'. If this is the
case then you have successfully connected your clock radio to your
network, so please proceed to the section 'Once your clock radio is
connected to the network' on the next page.
11. If the screen displays either 'Enter WEP key' or 'Enter WPA key', it is
because the network is using one of the encryption systems: Wired
Equivalent Privacy (WEP) or Wi-Fi Protected Access (WPA). You
therefore need to enter the correct WEP or WPA key into the clock
radio to allow it to communicate with your wireless network.
8
7
7
Confi guration
9