Instruction manual

If you do not have the WEP or WPA key, then you should obtain it

from the person who set up your network. Some wireless routers may

come with an encryption key already set up by the supplier, in which

case you should refer to the user documentation provided with it.

WEP keys are 10 or 26 characters long (using 0 - 9, and A - F). Some

Wi-Fi access points can also use pass-phrases for WEP but these do

not conform to a deﬁ ned standard and are not supported. WPA keys

are usually set up using a pass-phrase of between 8 and 63 characters.

Your Internet radio can accept pass-phrases for WPA keys.

If the WEP or WPA key was previously entered and the radio has not

had a factory reset the display will show 'Using saved key' and should

then connect to the network.

12. After 3 seconds, the display goes into the key entry mode. To enter the

key, use the Tuning Up or Down buttons to select each character of

the key in turn, when the character is central on the display press the

Select button after each character. Remember, WEP keys only use

the numbers 0 - 9 and letters A - F. WPA keys are sensitive to upper

and lower case characters so you must enter them exactly.

13. If you make an error use the Back button to delete the character

entered.

14. After the ﬁ nal character of the WEP or WPA key has been entered,

centrally locate the 'END' symbol and press the Select button.

Alternatively the 'END' symbol can be quickly accessed by pressing

the Add/RDS button. The clock radio should now be able to connect

to the network.

15. Once your clock radio is connected to the network (and therefore also

to the Internet) it will display the time and the main Mode menu. This

menu provides access to all major functions of the radio. The time is

obtained from the internet by the radio. If the time display is not correct

for any reason, it can easily be adjusted later, see page 40 'Manually

setting the clock'.

12,14