Specifications

Surface to Surface
M3-G
Week End Shut Down
• Pump or drain remaining mixed slurry product out of your tank and dispose of it according to local
environmental approved practices.
• Make sure “Tank Gun” valve is open.
• Rinse tank with clear water and then pump through the system, removing as much of the slurry mix in
the system as possible. Open the valve on the wash wand to flush with fresh water, back into hopper.
• Drain the remaining water out of your tank and dispose of it according to local environmental approved
practices.
• Remove centrifugal pump front cover and clean. Replace cover carefully to avoid damage to the seals.
DO NOT over tighten Tee handle nuts.
• Make sure “Tank Gun” and wash wand valves are open.
• Remove filter / shear and clean as described in the maintenance section of this manual.
• Prolonged periods of storage require extra care of the pump to protect from rusting. Take pump apart to
dry and spray with a protective oil film.
• Prolonged periods of storage require engine preparation. See engine operators manual.
READ CAUTIONS AT FRONT OF MANUAL REGUARDING THIS OPERATION!
Winter and Freezing Weather Shut Down
• Pump or drain remaining mixed slurry product out of your tank and dispose of it according to local
environmental approved practices.
• Make sure “Tank Gun” valve is open.
• Rinse tank with clear water and then pump through the system, removing as much of the slurry mix in
the system as possible. Open the valve on the wash wand to flush with fresh water, back into hopper.
• Drain the remaining water out of the tank and dispose of it according to local environmental approved
practices.
• Remove centrifugal pump front cover and clean inside. Leave cover off. This will let remaining moisture
to drain.
• Make sure “Tank Gun” and wash wand valves are open.
• Remove filter / shear and clean as described in the maintenance section of this manual. Leave filter /
shear out of housing as this will allow remaining moisture to drain.
• Open the hopper valve and pour in a suitable environmentally friendly anti-freeze.
• Shut the hopper valve and pour a suitable environmentally friendly anti-freeze into the hopper until
about 2” of fluid cover the valve. This will stop the valve from freezing around the edges.
READ CAUTIONS AT FRONT OF MANUAL REGUARDING THIS OPERATION!