Specifications

Surface to Surface
M3-G
CAUTIONS
continued
CARE must be taken that the coupler gaskets are properly installed or a leak may develop.
IT is imperative that all suction line connections do not leak. The M3-G uses the vacuum created by
the venturi jetting to draw fresh water into the reservoir tank.
NEVER leave liquid in the pump casing in freezing weather conditions, damage will result. Follow
instruction in this operator manual for winterizing.
IF the intent is to take water from a ditch or pond, it is recommended that a very fine screen be
placed over the inlet of the hose, to stop the introduction of foreign material into the M3-G system.
Alternative Uses & Moving
CAUTION should be used when considering alternative uses for this equipment. This unit was
designed for mixing & blending of bentonite and drilling additives. The manufacturer should be
consulted.
WHEN lifting this unit, the polyethylene tank must be empty of fluid or damage may result.
LIFTING lugs or the lift points identified in the skid structure must be used in order to safely lift the
unit.
Safety Markings
Hazard and warning markings have been placed at appropriate points on the unit. International symbols
have been used, in order to ensure universal understanding of the nature of the hazard. Please comply
with all warnings and markings to ensure safe use of the equipment. These include but are not limited to:
a) Lifting points
b) Flammable liquids
c) High temperature areas
d) Eye protection recommendations
e) Ear protection recommendations
f) Dust mask recommendations
g) Manual requirements
h) Accessibility restrictions.