Specifications

Surface to Surface
M3-G
Mixing Operation
• Operate engine at high speed.
• Open butterfly valve at bottom of hopper where it joins the venturi mixing tee.
• Introduce the dry or liquid raw material into the hopper.
• Suction created by the venturi mixing tee will draw the raw material into the jet stream for initial mixing.
• Flush jetting tee with wash wand.
• Close the butterfly valve on the hopper to keep debris out of the system.
• Allow the mixing system to circulate the product until the desired consistency is attained.
READ CAUTIONS AT FRONT OF MANUAL REGUARDING THIS OPERATION!
Transferring Operation (product outflow)
• On the left end of the skid base, you will see a 1-1/2 in. ball valve (1-1/2”NPT.) connected to the filter /
shear housing of the M3-G marked “Drill Fluid”.
• A transfer hose with a minimum size of 1-1/2 in. is to be attached to the ball valve to carry the finished
product to a holding tank or direct to the drill rig.
• Make the necessary connections at the holding tank or drill rig.
• Run the M3-G pump at favorable speed and open the ball valve to allow the flow to the holding tank or
drill rig.
• The speed and pressure of the fluid outflow is determined by the engine speed and valve setting.
READ CAUTIONS AT FRONT OF MANUAL REGUARDING THIS OPERATION!
Daily Shut Down
• Set the speed control lever at the low speed position and allow the engine to run at low speed for 2 or 3
minutes.
• Rotate the stop button until the engine stops. Do not stop engine suddenly while running at high speed.
• Close the fuel cock.
• Pull the recoil starter handle slowly until resistance is felt and then return the handle to its original
position. Note
- This operation is necessary to prevent outside moist air from intruding into the combustion
chamber.
• Close any valve(s) installed on suction line between pump and tank.
• Remove filter / shear as described in maintenance section.
• Clean filter / shear as described in maintenance section.
READ CAUTIONS AT FRONT OF MANUAL REGUARDING THIS OPERATION!