Specifications
8-2-4
MAIN SYSTEM
1)
Remove the bolt
(21)
and take out float chamber body
(23).
2)
From the body
(1)
remove the main nozzle
(1
8),
and then remove the main jet
(20)
from the main
/"-
nozzle
(1
8).
3)
Reassembly
a) Fasten the main jet securely
to
the body. Otherwise, the fuel may become too rich and cause engine
b)
The bolt tightening torque
is
70
kg-cm.
malfunction.
8-2-5
FLOAT SYSTEM
1)
Pull out the float
pin
(1
6)
and remove the float
(1
7)
and needle valve
(24).
If the needle valve need be re-
placed, replace it with rubber needle.
Caution: When cleaning the jets, use neither
a
drill nor a wire (because of possible damage of the orifice
2)
When removing the needle valve and flots, gently tap the reverse side using the rod more slender than the
which will adversely affect fuel flow). Be sure to use compressed
air
to
blow
them clean.
float pin and remove because the float
pin
is
calked to the carburetor body.
/"
-
34
-