Service manual

– 40 –
3) Checking items after assembly
(1) Try to pull the starter handle for 2 to 3 times.
(a)When the starter handle is difficult to pull, please make sure the parts, etc., are installed in the right direction.
(b)When the ratchet does not operate, please re-check if there are any missing parts such as the spring.
(2) Pull the starter handle and try to pull the starter rope out to the limit.
(a)When the starter rope remains in the rope groove of the reel, pressure is put on the spring. Pull out 30cm of
the starter rope, holding the reel firmly with your thumb, and then pull the starter rope out towards of the
recoil starter. Next, rewind it 1~2 times, controlling reel rotation.
(b)When the starter rope does not return smoothly, or the starter handle is hangs down loosely, please add
grease or mobile oil in the rotating and friction parts.
If it still does not work, rewind 1~2 times.
(In that case, confirm that the spring is not under pressure by following the previous procedure.)
(c)Please re-assemble from the beginning if there was the sound when the spring was removed and the starter
rope does not re-winded into the reel.
-2 Wind the rope clockwise seven times with the rope
hanging from the reel.
Gently wind the rope onto the reel while
removing any kinks in the rope from the knob side.
Wind up for
seven times
clockwise
Rope
Cut of the reel
Assembly is completed.
※These are the disassembly and assembly procedures, please be sure to review the following item checklist to
insure that the parts securely installed.