Service manual

- 31 -
STATOR COVER
(6) Remove the rear cover
RGX7100 M6 × 180mm    4 pcs
RGX7800 M6 × 195mm    4 pcs
(7) Take out stator cover with crows (2 pcs)
raised up by using screw driver
(8) Remove the stator
NOTE:Thestatorisheavy.Becarefuldonot
hitthecoilofthestatortotherotor.
(9) Take off the through bolt of the rotor
(10) Use a bolt and oil as a tool for pulling out
rotor in the following procedures :
1 Pour engine oil into the center hole of
rotor shaft Fill with oil to the shaft end
2 Prepare a bolt with the following thread
size : M12 × 175 (RGX7100
/ RGX7800 )