Manual

3
Vacuum
Pump Oil
Oil
Change
Procedure
To shut down the pump after use . . .
To help prolong pump life and promote easy starting, follow these procedures for
shutdown:
1. Close the manifold valve between the pump and the system.
2. Remove the hose from the pump inlet.
3. Cap the inlet port to prevent any contamination or loose particles from
entering the port.
To maintain your high vacuum pump . . .
 
pump oil after each use.
The condition and type of oil used in any high vacuum pump are
extremely important in determining the ultimate attainable vacuum.


normal running temperatures and to improve cold weather starts.
 
your convenience. Please order by part number:
13119 — Pint (shipped 12 pints per case)
13203 — Quart (shipped 12 quarts per case)
  
1. Run the pump for approximately one minute to warm the oil.
 
container, and dispose of it according to local, state, and federal
regulations.
 
residual oil.
 