User Manual

16910 CoolTech ID Plus Refrigerant Identifier

Hardware Descriptions

The Identifier provides the user with a complete tool to identify refrigerant mixtures, and

rid the mixtures of air contamination, all housed in a portable, rugged carrying case.

Housing

The instrument is housed in a rugged, hand-held, injection-molded nylon case. The case

houses the sensing devices, the plumbing system, and the electronics of the instrument.

Power Cord

A nine-foot (2.75 meter), molded, three-prong, grounded, NEMA, power supply cord is

attached directly to the instrument. Different power cords may be supplied if the instrument is

to be used in areas outside North America.

Sample Filter

The sample filter provides retention of particulate and oil mist suspended within the

sample vapor. The filter is supplied with a red, maintenance-indicating dye. As soon as red

spots or discoloration begin to appear anywhere on the white outside diameter of the filter

element, THE FILTER MUST BE REPLACED. Failure to replace the filter when indi-

cated may lead to severe instrument damage that is not covered under warranty repairs.

Air Intake Port

The air intake port is located at the top of the instrument and provides the entry point for

ambient air into the instrument during calibration procedures. Never obstruct the port

during use of the instrument.

Sample Exhaust Port

The sample exhaust port, located on the bottom edge of the instrument, will emit spent

sample gasses. Keep this port clear and unobstructed during use.

Sample Inlet Port

The sample inlet port admits refrigerant vapor into the instrument through the connection

of the mating end of the sample hose.

System Pressure Gauge

The system pressure gauge indicates to the user the presence of a refrigerant sample flow

into the instrument