Installation and Operation Guide

4
Connecting the Ironing Centre to Electric Power
o For recessed mount, an external ON/OFF (safety) switch for the Ironing Centre must be installed near the unit.
An additional power socket can be installed inside the wall between the switch and power plug.
o Alternatively the unit can be hard wired directly to the switch by an electrician.
o For surface mount, the Ironing Centres’ plug and lead can be easily plugged into a nearby wall socket, or can
be hard wired by an electrician. (The electrical safety standard requires the following “Switches shall be directly
connected to the supply terminals and shall have a contact separation in all poles, providing full disconnection
under overvoltage category III conditions”).
Door Assembly Handle Instructions
Mounting the handle to Cabinet Door
4. To fix handles to the drawer, firstly clear the existing holes from the front using the screws
supplied. Insert screw & washer from the inside (back of the draw front) of the drawer, place
handle on the outside of the drawer front and secure in two locations. Be careful not to scratch the
drawer fronts whilst installing the handles.