Installation and Operation Guide

1. Disconnect Ironing Centre from power supply. Ensure the power is switched off.

2. Insert small screwdriver or slim knife as shown, ease catch to side and slip out diffuser.

3. Replace lamp (40 watt max.)

4. Slide diffuser back into aperture and “click” into place. Turn power back on.

Board rotation

3. Make sure the door is clear if the board is to be rotated.

4. With the board in the horizontal position hold the board with both hands (NOT BY THE NOSE) and

rotate around the centre pivot the unit will click into the required position.

NOTE: In order to store the Ironing board, it must be on its lowest position and rotated back.

Lamp Replacement