Issue 3 Description: ROBINHOOD POWERPACK RANGEHOOD Model Numbers: RPB3CL6SS/WH, RPB3CL9SS/WH Product may vary slightly from the picture
Pre-installation Thank you for purchasing a quality Robinhood rangehood. Robinhood has a high standard of quality control and every rangehood is tested and approved before it leaves the factory Important: Please read the entire instructions before installing the rangehood, always switch power off prior to installation. All electrical work must be done by a registered electrician in accordance with local and national electrical codes as applicable. For your safety, this product must be earthed.
Pre-installation •The Rangehood is designed for hood installations between 650 to 750mm above the cooking surface* •Any installation above 750mm will compromise the extraction performance. •The air outlet from the motor requires 150mm round ducting which requires 170mm diameter hole in the ceiling if ducting through the ceiling.
Pre-Installation - continued Contents of packaging: Typical equipment required: 1 1 2 1 electric drill and screwdriver tape measure and spirit level step ladder duct tape (if ducting) jig saw (if ducting) ladder (if ducting) x x x x rangehood packet of fasteners face plates Installation and Operating Instructions Ducting Options The method of ducting should be carefully considered before installing the rangehood.
Installation Before drilling any holes check that the area behind the surface to be drilled is clear of any electrical cables, pipes etc. The ceiling must take a weight bearing of at least 40kgs weight. Whenever possible protect the Rangehood with a fabric sheet or similar. When installing the rangehood, the lower edge of the unit must be a minimum of 600mm (650mm for gas cooker) above the cooking range. The recommended position for the hood is 650mm above the hotplates.
Installation •Mounting the Rangehood •Fit the ducting adaptor to the rangehood using the short screws supplied. •Provide an opening on the underside of the cupboard to suit models/ provide 490mm x 258mm for 600 model or 665mm x 258mm for 900 model. •Remove both LED Bulbs from their sockets. •Remove the face plate of the rangehood by undoing the two visible screws located on both sideends. Eight mounting holes around the unit then are accessible.
Control Panel 1. Plug the Rangehood to power. 2. Push the low speed button and the motor runs at low speed. Push the power button and the motor will stop. 3. Push the mid speed button, and the motor runs at mid speed. Push the power button and the motor will stop 4. Push the high speed button and motor runs on high speed. Push the power button and the motor will stop 5. Push the light button; the LED lamps will come on. Push it again and the lamps will turn off.
Product approvals and ratings Product rating 220-240V, 50Hz, Total Power 274W, motor270W, Lamp 2 x 2W, Class I Electrical approval AS/NZS 60335.2.31:2004 + A1 + A2 + A3 + A4 EMC AS/NZS CISPR14.
Warranty Certificate (New Zealand) Terms and Conditions The following conditions apply in respect of the warranty given in this certificate: 1. Monaco Corporation Limited (“Monaco”) warrants the following Robinhood products against manufacturing defects and faulty materials, under normal use and subject to the exclusions in this certificate, for a period of: Rangehood, Ovens, Cooktops, Dishwashers - 24 months from date of original purchase for domestic use.
Warranty Certificate (Australia) Terms and Conditions If you are a consumer under the Australian Consumer Law, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure 1.
