Installation and Operating Instructions Model Numbers: RWC3CL6SS RWC3CL9SS RWC3CL6WHT Description: Wall Canopy Rangehood Pictured: RWC3CL6SS
Contents Congratulations! Thank you for choosing one of our appliances. Before you use the appliance, we strongly recommend that you read through the whole user manual which provides important safety instructions and description of the product and the proper use of its functions. To avoid the ever‐present risks involved with using an electrical appliance it is vital that the oven is installed correctly and that you read the safety instructions carefully to avoid misuse and hazards.
Important Safety Instructions IMPORTANT: Read the assembly instruction section and safety precautions of this booklet carefully before removing the contents of this carton. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. In certain circumstances electrical appliances may be a safety hazard.
Appliance Details Voltage and Frequency: Lamp Max: Rated Input Power: 220-240V 50Hz RWC3CL6SS: 2 x 3W GU10 LED RWC3CL9SS: 2 x 3W GU10 LED RWC3CL6WHT: 2 x 3W GU10 LED RWC3CL6SS: 196W RWC3CL9SS: 196W RWC3CL6WHT: 196W General Information Before installing and operating the rangehood, carefully read the following important information regarding installation safety and maintenance. Keep this information booklet accessible for further consultations.
Pre-Installation Ducting Options Ducting Options The method of ducting should be carefully considered before installing the rangehood. The guide below recommends the ducting components to use for all common ducting configurations - through the top of the home (for the roof and soffit) and through the rear of the home. 150mm round ducting should be used in conjunction with this model rangehood. Alternatively this rangehood can be operated in recirculation mode.
Pre-Installation Installation position A. Minimum height from the hob surface to the underside face of the rangehood: 650mm. Notes: If the instructions for the gas hob specify a greater distance, this has to be taken into account. Any installation above 750mm will compromise performance. B. Vertical height from bottom of Rangehood to Fixing Plate mounting screws 323mm. C. Distance between mounting screw holes on Fixing Plate 100mm.
Installation Mounting to a stud is recommended. However, if fitted to other wall linings (plasterboard, concrete etc) suitable fixings will be required. Before drilling any holes check that the wall and ceiling are clear of any electrical cables, pipes etc. 1. Pre drill pilot holes in the positions given. Fix the fixing plate using the screws supplied or appropriate wall fixings, check with a spirit level to ensure bracket is level. Tighten screws. 2.
Installation 5. Connect and secure the ducting (use duct tape if required). 6. Remove the protective plastic covering from all parts including the filters. Fit the canopy hood on the fixing bracket. Mark and drill the two holes required for the safety screws. Secure the canopy in place with the safety screws provided. The safety screws stop the canopy from accidently being knocked off the fixing plate. 7. Insert the upper chimney piece into the lower chimney piece.
Operating Instructions Controls Power On / Off Speed 1 Speed 2 Speed 3 Lights On / Off Light The light can be operated independently from the fan and is controlled in accordance with the graphics printed above. Fan The fan is operated by turning the power switch on. It can be run at three different speeds (Speed 1 / Speed 2 / Speed 3) depending on the cooking requirements and is controlled in accordance with the graphics printed above.
Replacing the Lights Warning: Before attempting to replace the lights, ensure that the appliance is switched off and unplugged from the wall socket. Ensure that the light is cool before touching. • • • • Remove the aluminium filter. Press the light face and turn anti-clockwise to remove. Replace with an identical light: o Type: GU10 LED o Max Wattage: 2 x 3W o Voltage Range: 220 – 240V AC o ILCOS D Code: DR-3/65/1B-H-GU10-46/50 Replace the aluminium filter.
Warranty Certificate (New Zealand) Terms and Conditions The following conditions apply in respect of the warranty given in this certificate: 1. Monaco Corporation Limited (“Monaco”) warrants the following Robinhood products against manufacturing defects and faulty materials, under normal use and subject to the exclusions in this certificate, for a period of: • Rangehood, Ovens, Cooktops, Dishwashers, Refrigeration - 24 months from date of original purchase for domestic use.
Warranty Certificate (Australia) Terms and Conditions If you are a consumer under the Australian Consumer Law, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. 1.