Issue 4 Description: ROBINHOOD WALL CANOPY CURVED GLASS 90CM VETRO Model Numbers: RWV3CL6G, RWV3CL9G Product may vary slightly from the picture (RWV3CL9G pictured)
Pre-installation Thank you for purchasing a quality Robinhood rangehood. Robinhood has a high standard of quality control and every rangehood is tested and approved before it leaves the factory. Important: Please read the entire instructions before installing the rangehood, always switch power off prior to installation. All electrical work must be done by a registered electrician in accordance with local and national electrical codes as applicable. For your safety, this product must be earthed.
Pre-installation •The canopy hood is designed for 2400mm-2700mm** ceilings. •**For 2700mm ceiling height, the hood must be installed at 750mm above standard 900mm height bench top •The chimney is telescopic and is designed for hood installations between 650 to 750mm above the cooking surface. •Ascertain the desired installation height of the canopy hood. •Any installation above 750mm will compromise the extraction performance.
Pre-Installation - continued Contents of packaging: Typical equipment required: 1 1 2 1 1 electric drill and screwdriver tape measure and spirit level step ladder duct tape (if ducting) jig saw (if ducting) ladder (if ducting) x x x x x rangehood packet of fasteners and wall plugs chimney pieces (upper and lower) chimney bracket Installation and Operating Instructions Ducting Options The method of ducting should be carefully considered before installing the rangehood.
Installation Control Panel Timer switch Canopy hood will remain on a low, mid or high speed for 15 minutes to clear away all residual cooking odours before switching off automatically Wall / ceiling preparation Recirculation For recirculation, do not cut 170mm hole and purchase a charcoal filter.
Installation & Hardware Hardware Provided: 4pcs screws ST5x40 (40mm), 2pcs screws M3x12 (12mm), 4pcs anchor wall plug, 4pcs washers 1. Pre drill pilot hole 3mm diameter at dimensions C and B. 60cm hood; B=305mm and C=170mm to centre of bracket. 90cm hood; B=310mm and C=230mm to centre of bracket. 2. Loosely fix 2x mounting screws (ST5x40, 40mm) and 2x washers in position, drilling into 2x anchor wall plugs (supplied). Check with a spirit level across the washers to ensure they are level. 3.
Product approvals and ratings Product rating 223W, 220-240 Volt,50 hertz Electrical approval AS/NZS 60335.2.
Warranty Certificate (Australia) Terms and Conditions If you are a consumer under the Australian Consumer Law, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure 1.
Warranty Certificate (New Zealand) Terms and Conditions The following conditions apply in respect of the warranty given in this certificate: 1. Monaco Corporation Limited (“Monaco”) warrants the following Robinhood products against manufacturing defects and faulty materials, under normal use and subject to the exclusions in this certificate, for a period of: Rangehood, Ovens, Cooktops, Dishwashers - 24 months from date of original purchase for domestic use.
