ST9001W Issue: 2 Description: ROBINHOOD SUPERTUB WORKSTATION Model Number: ST9001W / 9001WA Model pictured: ST90001W/ST9001WA All dimensions in mm Model may vary slightly from images pictured 1
Overview Contents of packaging: 1 x Robinhood Supertub (incl waste system, plug) 1 x Installation kit (incl feet) 1 x Tap ware (incl flexible hoses, support plate, fixing plate, nuts) 2 x Handles, washers and screws. Pre-installation Important: o Please read the entire instructions before installing the laundry tub. o Ensure the household pipes are thoroughly flushed to remove debris before connecting your laundry tub to the pipe works.
Installing the Supertub Confirm if the washing machine waste inlet needs to be moved from right to left before securing the unit to the wall. If they do need to be changed see page 6 of these installation instructions. 1. To ease installation, remove all three drawers, handles and washing machine hose. To remove a drawer, simply slide the drawer out to its full extent, lift the front and pull to remove. 2.
Installing the Supertub 7. Position the laundry tub and cut the house waste pipe (which should already be installed) to the exact height. The final height will depend on the waste trap dimensions. 8. Fasten the laundry tub to the wall through any of the holes in the rear flanges. Alternative fastening can be achieved through the floor. Confirm that the drawers operate correctly. 9.
Operating Instructions 1. To use the washing machine from the mains water supply, simply turn the washing machine 3 way ball valves knob quarter turn valve on. 2. To isolate the washing machine from the mains water supply, simply turn the washing machine 3 way ball valves knob quarter turn off. This will isolate the washing machine from the mains water supply but still allow water to flow through the laundry tub tap.
Adjusting the height of the drawers and fixing the handles 3. To fix handle to the drawer, firstly clear the existing holes from the front using the screws supplied. Insert screw & washer from the inside (back of the draw front) of the drawer, place handle on the outside of the drawer front and secure in two locations. Be careful not to scratch the drawer fronts whilst installing the handles.
Suggested plumbing fittings required for Australian installations Your ST9001WA Supertub is supplied with a standard 40mm waste fitting and this will require either a S or P trap for connection to your household plumbing, using the suggested parts below or as required by your licensed plumber.
Warranty Certificate (New Zealand) Terms and Conditions The following conditions apply in respect of the warranty given in this certificate: 1. Parbury Pty Limited (“Parbury”) warrants the following Robinhood products against manufacturing defects and faulty materials, under normal use and subject to the exclusions in this certificate, for a period of: Uniduct – 12 months from date of original purchase for domestic use.
Warranty Certificate (Australia) Terms and Conditions The following conditions apply in respect of the warranty given in this certificate: 1. Parbury Pty Limited (“Parbury”) warrants the following Robinhood products against manufacturing defects and faulty materials, under normal use and subject to the exclusions in this certificate, for a period of: Rangehood - 24 months from date of original purchase for domestic use.
