Operation Manual

46 V0214 D 510
Nederlands Français English Deutsch
Starting up the machine (Fig.5)
Turn the main switch to position “1” in order to put the machine under tension.
To start up the motor in the manual starter version, set the ‘Star-Delta’ switch in the ‘Star’ position and
push the start button, after about 5 sec. turn the switch to the ‘Delta’ position. For the optional ‘Auto-
Star-Delta’ push the start button, the motor starts-up automatically in Star-Delta. By pushing the stop
button the main motor is automatically stopped, and slowed down by the automatic brake within 10
seconds.
The feeding motor can be started by pushing the start button and by turning the knob of the feed selec-
tor switch the feeding speed can be chosen from 5/8/10 and16 meters per minute.
To stop the feeding motor, push the stop button.
All motors are stopped automatically when the emergency stop button is used.
Make sure the brake release switch is set at position O and the warning light next the same button is
not lit, in order to be able to start up the machine.
When this same switch is pushed during the run of the machine the motors will automatically be
stopped.
Table up-and
down
Position table
Main On-Off switch
Manual ‘Star-Delta’ switch for
Standard machine
Stop feeding
motor
Start feeding
motor
Start main
motor
Brake release switch
Selector switch
4 speeds feeding
Emergency stop
Fig.5