Operation Manual

48 V0214 D 510

Nederlands Français English Deutsch

Safety measures on the thicknesser

1. Check iff the planer knifes are well tighened and secured. When this is not the case the knifes, by

the centrifugal force, will be ejected from the cutter block.

It is absolutely essential to read this manual before using the machine so you know how to the

machine works and what it’s limitations are.

2. Always make sure that all safety devices are ﬁtted to the machine and that the machine is con-

nected to a dust extraction system.

3. Always wear suitable clothing, loose or torn clothes are very dangerous.

4. Keep children away from the machine and out of the workshop.

5. To avoid damaging your hearing we recommend to wear ear protection, when working with the

machine.

6. The height of a planer knife must be 20 mm minimum!

Adjusting the depth of cut (Fig.7)

Setting the depth of cut is easy and simple by using the two push buttons for the rise and fall of the

thicknesser table. The position of the thicknesser table can be set at 1/10 mm.

Calibration of the digital read out (Fig.7)

It is highly recommended that each time the planer knives are changed, the digital read out is calibrat-

ed, this to avoid measurement errors.Calibration is done as follows:

- set the thicknesser table at a random height and thickness a sample.

- now measure exactly the thickness of the sample.

- now the digital read out has to be set at the same measure, and this can be achieved as follows:

press simultaneously the buttons F and SET on the read-out:

Now the read-out begins to count up at 3 progressive speed rates:

- Rate 1: at 1Hz for 10 sec.

- Rate 2: at 10 Hz for 10 sec.

- Rate 3: at 1000 Hz for as long as the 2 buttons F and SET are held.

Shortly before the desired value is reached, release the two buttons and press the same two buttons

so as to approach the desired value with the slowest rate of 1 Hz.

The thicknessser now is calibrated over the full 250 mm capacity.

To set the read-out at 0, simultaneously press Set and RESET.

Tafel op en

neer

Fig.7