Operation Manual

E300 / E 2800 V0913 13

EnglishDeutsch

Use and adjustment of the riving knife

(Fig.11)

The machine is equiped with a riving knive for the use of sawblades upto 315 mm.

The riving knife has to be adjusted in such a way that over its entire length the gap between sawblade

and riving knife does not exceed min.3 mm and max.8 mm.

The riving knife (1) can be adjusted in both vertical and horizontal direction.

The height setting has to be adjusted in such a way that the highest point of the riving knife never

exceeds more than 3 mm above the highest placed sawblade tooth.

After height adjustment always lock the central bolt (3) (with 25Nm). The 3 little adjustment screws (2)

are used for the exact setting of the riving knife in line with the sawblade.

For slotting or grooving the riving knife has to be adjusted in such a way that the upper part of the

riving knife is never set lower than the highest sawtooth in use.

Never remove this riving knife. Kickbacks are severe and very dangerous.

Fig.11

Fig.12