Operation Manual

E300 / E 2800 V0913 17

EnglishDeutsch

Mounting of the cross-cut table (Fig.16)

The cross-cut table can be slid from the back onto sliding table via the at bar on the side of the

sliding table.

The 2 brackets (2) should be positioned to allow the cross-cut table to be easily moved along the

sliding table. The table is locked in position using handle (1).

Please note that the machine is constructed so that the cross-cut table can only be put at the far end

side of the sliding table.

The telescopic arm support is too short to allow the cross-cut table to be set at the front of the sliding

table. Both telescopic arm and cross-cut table are factory set and need no further adjustment.

Mounting of the 90° cross-cut fence

(Fig.17)

The cross-cut table has 4 precision holes allowing the fence to be put in 2 positions : at the back and

front of the cross-cut table. Simply put the fence onto the cross-cut table and lock it in position

using the two serrated nuts (1).

The 90° right angle of the fence is factory set. Should the 90° angle need to be adjusted, then the two

bolts (2) must be loosened; then by turning the little bolt (1), the angle can be opened or closed

towards the sawblade. After adjustment the bolts (2) have to be retightened.

Fig.17

Fig.16