Operation Manual

E300 / E 2800 V0913 19
EnglishDeutsch
Use of the parallel fence (Fig.20)
To move the fence, unlock the serrated knob (3) and lift the handle (2).
To lock the fence in position push the handle (2) down and lock the knob (3).
The micro adjustment is achieved by locking the knob (3), by holding the handle (2) in the upright
position and by turning the serrated knob (4).
After the adjustment push handle (1) down to lock the fence in place. When cutting small workpieces
with the sawunit inclined at 45°, the fence should be used in the low position.
Simply unlock the eccentric clamping handle (5), slide off the fence and slide it back on in the low
position.
Lock the fence with the eccentric clamping handle (5).
When cutting solid wood using the parallel fence, to avoid the wood getting stuck between the fence
and the riving knife (resulting in a hightly dangerous kickback) it is recommended to reposition the
fence so that its end protrudes just past the end of the riving knife.
Fig.20
1
5
3
4
2