Operation Manual

E300 / E 2800 V0913 5
EnglishDeutsch
adjustMent and InstallatIon
Disconnect the machine from the power supply before every adjustment.
The recommendations of the manufacturer must be followed when adjusting and installing the tools.
The tools must be suited to the material being cut to assure safe and efficient sawing.
The tools must be correctly sharpened and installed.
handlIng oF tools
Always wear safety gloves when handling saw blades thus avoiding severe injury to the hands. Bear in
mind that even blunt tools can cause serious damage.
norMal and prohIBIted use
The panel saw is designed for the following work and is equiped with protective devices for these
processes only.
It is not designed to work materials such as ferrous or non-ferrous metals, work different from that
stated below is prohibited.
Ripping with the parallel saw fence with/without the sawblade tilted and the fence upright or in the
low position.
Right-angled or mitre cuts with the 90° fence mounted to the sliding table with tilted or vertical
sawblade.
Cross-cutting workpieces using the adjustable stop on the 90° fence.
Cutting panels or solid wood on the sliding table.