Operation Manual

20 V0913 E 300 / E 2800

English Deutsch

Calibration of the scale on the parallel

fence (Fig.21)

Each time a new sawblade is tted the parallel fence scale has to be calibrated to the new

sawblade.

By cutting a sample and measuring its exact length, the scale can be adjusted so that the exact

measure corresponds with the front side of the fence.

After the screw (1) has been loosened the scale can be adjusted. To avoid the fence contacting the

sawblade while it is revolving, the stopring (2) has to be adjusted.

Slide the fence to about 10 mm from the sawblade.

Now slide the stopring (2) across the round guide bar (3) until it comes up against the

casting of the fence. Tighten the lock screw on the stop ring.

Sawguard (Fig.22)

For safety and health reasons it is highly recommended to connect the machine and the saw guard to

a dust extractor system.

Both outlets on the machine (dia.100 mm) and on the saw guard (dia.25 mm) need to be connected,

and the dust extractor should be powerfull enough to obtain an airow of at least 20 m/sec.,

measured at the outlet on the machine.

The guard has to be adjusted in such a way that both main and scoring sawblade are covered, and

should be adjusted in height so that the workpiece can slide under the guard.

Always ensure the locking handle (2) is well tightened.

Fig.22

Fig.21