Operation Manual

E300 / E 2800 V0913 21

EnglishDeutsch

Belt tension (Fig.23-24)

Main sawbelt (g.23)

After removing the machine access door the belt can be loosened by unlocking the 4 bolts which

holds the motor.

When putting new belts, always ensure the belt is well positionned into the pulley’s groove.

Tension the belt by pushing the motor to the back, and lock the 4 bolts.

Make sure the belt is not overtensioned, because this leads to damage of the saw arbor and belt.

Check regularly the condition of the belt and, if necessary, replace it using only original Robland belt

(partnr. NXPZ 577).

Scoring sawbelt (g.24)

To tension the scoring sawbelt loosen the two nuts (1-2) which hold the motor, push the

motor down, tighten the two nuts while pushing the motor down.

To change the belt remove the motor completely. When the belt is replaced, but before

tensioning it, ensure that it is correctly seated into the grooves of both pulleys.

Use only original Robland belt (partnr. NPV140 J8).

Fig.24

Fig.23