Operation Manual

16
15
Adjusting the riving knife (fig. 8)
The saw is equiped with a riving knife suitable for saw blade diameters of 200 to 300 mm.
Never cut without the riving knife! Kickbacks are highly brutal and dangerous.
- Always set the riving knife close to the saw blade so that the gap never exceeds 3 mm.
The riving knife can be set perfectly in line with the saw blade by using the adjustment
screws.
- After adjustment always tighten the central locking bolt of the riving knife clamping.
Maximum distance 3 mm
Adjustment and locking bolts
fig.8
Tilting and adjusting the scoring saw (fig. 7.2))
By turning the handwheel at the front side of the machine, the whole saw unit can be tilt-
ed and set at any angle between 90°and 45°. After setting, lock the saw unit in this posi-
tion using the locking handle. The angle can be read at the scale.
The lateral movement of the scorer saw blade is achieved by turning the knob and lock-
ing the serrated knob.
The height setting of the scorer saw blade is done by turning the knob, and locking the
serrated knob.