Operation Manual

Tenoning guard and table option (fig. 24)
For tenoning, a special guard is mounted on the table.
This guard allows tools up to 250 mm diameter and is mounted in the same fixing holes as
used for the spindle fence (2).
The front cover plate (3) is adjustable in height with 2 knobs (4) and has to be set as low as
possible to assure maximum coverage of the tool for maximum safety.
The 2 locking knobs assure the horizonal movement and protection of the tool. The tenoning
plate is fixed onto the sliding table and has to be set as close as possible to the tool.
The woodclamp assures the clamping of the workpiece and has to be set as
close as possible to the tool.
Lockin
g
knobs for vertical and horizontal
p
r
otect
i
o
n
p
l
ate
Woodclamp
Tenoning table
Tenoning fence
locking handles
fig.24
25