Operation Manual

Saw belts
Drive belt tension
Circular saw:
Remove the cover plate between the saw-and spindle table and tilt the saw unit to 30° for
more easy access to the belts. By loosening the 4 bolts holding the motor to the cradle, the
belts can be tensioned by shifting the motor towards the spindle.
Type of belts: M38,5
Spindle unit:
Loosen the 2 bolts holding the motor to the column and pull the motor towards you in order to
tension the belts. (left bolt acts as hinge bolt)
Type of belts: M20
Planer-Thicknesser:
Loosen the 4 bolts holding the motor to the frame, and the motor, under it’s own weight will
tension the belts.
Type of belts three phase motor: SPZ 1412
Type of belts single phase motor: SPZ 1400
Drive chains
Planer-thicknesser belts
32
(fig. 34)
(fig. 35)
(fig. 36)
(fig. 34, 35, 36)