Operation Manual
NX SERIES V0913 21
– English
Transportation (g. 1, 2 en 3)
Depending on the method of transport or shipping, you will receive the machine in a case or on
transport blocks. The packing itself, made of bre plates, and the wooden beams can easily be
recycled. Take the sides of the crates and remove the carton and the other parts fastened to the bottom
of the crate. Take the machine of the pallet by means of lever bands.
Self pick-up: for self pick-up, the assembled machine is securely mounted on transport blocks.
The table surfaces and all exposed parts are covered with a protective plastic lm.
Avoid any impact when unloading the machine and never pull on the worktables or aluminium sliding
table.
Machine on pallet: move the machine on level ground using a pallet jack as shown in the drawing.
Use a wooden ramp made of thick board and wooden beams, and secure the ramp to the pallet in
order to avoid slipping of the ramp.
Never try to move the machine on rollers when its on an incline.
Once the machine is on level ground, move it with a pallet jack, or forklift.
Fig. 1, 2, 3
ATTENTION:
Always make sure that the useful loading capacity is big enough. Place the lever bands in such a way
that they don’t put too much pressure on the tables. Lift the machine a few centimetres to remove the
bottom of the crate.
Start-up:
Always make sure the machine wasn’t damaged during transport or whilst unloading. Place the
machine stable on a solid underground and make sure that there is enough space around the machine
to use it safely.
ATTENTION:
Working with woodworking machines in an unsafe way can be very dangerous. It is in your own
interest that you use all safety devices and protections.
Electrical connection (g. 4, 5 en 6)
The electrical connection must be carried out by a qualied electrician who is able to calculate exactly
the required wire section and amperage of the fuses.
– check that the main voltage of your machine corresponds with the voltage in your workshop;
– then open the electrical connection box at the back of the machine (g. 4);
– connect the 3 phases to the terminals marked L1, L2, L3 (g.5);
– if there is a neutral conductor (blue), it is connected to the terminal N;
– connect the earth (green + yellow) to the terminal marked with the earth symbol;
– check if the spindle runs freely before starting up the machine;