Operation Manual

NX SERIES V0913 23
– English
Mounting of the saw blade (g.7)
1 Slide away the table.
2 Open the lower saw blade cover plate (1).
3 Raise the saw blade to the highest point.
4 Now put the locating pin (3) in the saw table to block the saw arbor.
5 Tighten the saw nut with the hookspanner (4). Warning: left hand threaded saw arbor!
6 Do not forget to remove the pin which holds the saw arbor in place while tightening the nut.
Fig.7
Mounting of the scoring blade
Attention: for the changing of the main saw blade or the saw blade of the scoring unit,
disconnect the main switch en put the button on the « O » position.
In order to put, or change the scoring saw blade, slide the table to the rear far end and open the lower
saw blade cover.
This cover is equipped with a safety switch which prevents the motors from being started up.
Turn the scoring arbor to the left (see gure below 2) and put the spanner on the at sided arbor.
Put the Allen key into the bolt and loosen the bolt.
Make sure both scoring blade and saw arbor ange are clean!
Put the blade and tighten the bolt and close the cover.