Operation Manual

30 V0913 NX SERIES

– English

Drawing of the splinter protection (g. 16)

The fence is equipped with a splinter protection. When the splinter protection is damaged, it should be

replaced. It can be replaced by a piece of wood that has the following dimensions:

Fig.16

Mitre fence (g. 17)

The mitre fence is mounted on to the sliding table as shown on the picture. The at nut in the groove of

the table is factory set at 90°.

For tilting the mitre fence, loosen the vertical post (1) of the wood clamp and the Kipp handle (3) and

move the fence to the wanted angle.

The reading is done at the back of the support plate of the guide itself. Loosen both Kipp handles (2)

for moving the fence as close as possible to the saw blade.

Make sure that all handles are fastened after the adjustment of the fence.

To remove the fence from the table: loosen the vertical post (1) of the wood clamp and the Kipp handle

(3) and remove it.

Fig.17